Table of Contents
Advertisement
• Confirm that the mark of the gear matches with the
triangle mark on the reverse side of the tray in the tray
close status. (The gear is rotated with the slider locks.)
(Refer to Fig. B.)
Gear (4)
Gear (4)
The first tooth of the gear of
this side on the tray rack gear.
Marking
Tray (3)
Gear
Fig. 2-1-17
2-1-5. Rear Panel
1. Remove six screws (1) and remove the rear panel (2).
Fig. 2-1-18
Fig. A
Triangle mark
Position of the line
Pickup mechanism
assembly
Slider
Triangle mark
Fig. B
Screws (1)
Rear panel (2)
2-2. PC Board Replacement
2-2-1. Main PC Board
Note:
• Before removing the main PC board (4), be sure to
short-circuit the laser diode output land.
After replacing, open the land as it was after inserting
the flexible cables (1).
1. Remove the top cover. (Refer to item 2-1-1.)
2. Eject the tray. (Refer to item 2-1-3.)
3. Remove four flexible cables (1) and remove one
connector (2).
4. Remove seven screws (3) and the main PC board (4).
Twist more than 9 times.
Flexible
cable (1)
Tray
2-7
Flexible
Connector (2)
cables (1)
Screws (3)
Main
PC board (4)
Flexible
cable (1)
Screws (3)
Pickup head
Laser diode
output lands
Fig. 2-1-19
Advertisement
Table of Contents
