Pride Mobility LC-125 Quick Start Manual
Pride Mobility LC-125 Quick Start Manual

Pride Mobility LC-125 Quick Start Manual

Lift chair

Advertisement

Quick Links

Quick Start Guide
This Quick Start Guide offers basic information on initial Lift Chair setup only.
Read the owner's manual and all supplemental information thoroughly before
operating
troubleshooting and care and maintenance.

LIFT CHAIR ASSEMBLY

Your lift chair will be shipped in two pieces: the chair-back and chair base. Assembly is required before initial use.
Follow the instructions below for proper lift chair assembly. (Refer to the owner's manual for controller button
instructions.)
WARNING! You must ensure that the chair-back is properly secured before operating
the lift chair. Failure to do so may result in personal injury and/or property damage.

Tools Required:

5-mm hex key (1)
Follow these steps to assemble the lift chair:
1. Connect the hand control into the extension cable in the right pocket
2. Engage and hold the hand control's up/down switch in the UP position until the chair is in a fully lifted position.
3. With the pillow side of the chair-back and the lift chair armrests both facing the same forward position, slide
the bracket of the chair-back over the bracket on the chair base, aligning the holes in both brackets. Insert
the 4 bolts into the bracket holes and tighten with the provided hex key. See figure 1.
Rev D/June 2012

RECYCLING AND DISPOSAL

Cardboard may be recycled. Dispose of foam in accordance with
state or local ordinances.

READ BEFORE UNPACKING

Apparent Loss or Damage

Upon receipt of this shipment, if any evidence of loss or damage is
revealed through visual inspection, then it must be noted on the
freight bill and signed by the carrier's agent. Failure to do this may
result in the carrier's refusal to honor loss or damage claim. The
carrier will furnish you with the necessary forms to file the claim.

Concealed Loss or Damage

When loss or damage is not apparent until the unit is unpacked, a
claim for concealed loss or damage is required. When damage is
discovered, make a written statement to the carrier for inspection.
This request must be made within 48 hours of delivery. Keep all
cartons and fillers for inspection. Carrier will furnish inspection
report and necessary forms to file for concealed loss or damage
claim, since such damage or loss is the carrier's responsibility.
the
Lift
Chair
for
www.pridemobility.com
information
on
safety,
operation,
basic
*INFINFB2476*

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LC-125 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Pride Mobility LC-125

  • Page 1 Quick Start Guide RECYCLING AND DISPOSAL Cardboard may be recycled. Dispose of foam in accordance with state or local ordinances. READ BEFORE UNPACKING Apparent Loss or Damage Upon receipt of this shipment, if any evidence of loss or damage is revealed through visual inspection, then it must be noted on the freight bill and signed by the carrier's agent.
  • Page 2 Quick Start Guide 4. Plug the chair-back motor cable (labeled with a green-A tag) into the green-A slot of the controller box. Activate the actuator with the UP button extending the back actuator fully. 5. Remove the clevis pin from the motor mount, located on the back of the lift chair box.

Table of Contents