Important Safety Instructions For Using N2503Af Staplers - Hitachi N2503AF Instruction And Safety Manual

IMPORTANT SAFETY INSTRUCTIONS FOR USING STAPLERS
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE SHIELDS.
•
•
•
2. NEVER USE OXYGEN OR OTHER BOTTLED GASES. EXPLOSION MAY OCCUR.
•
•
•
3. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA.
•
•
•
•
•
4. KEEP FINGERS AWAY FROM TRIGGER WHEN NOT DRIVING STAPLES TO AVOID ACCIDENTAL FIRING.
Never carry the Stapler with finger on trigger since you could drive a fastener unintentionally and injure yourself or someone else.
•
Always carry the Stapler by the handle only.
•
5. CHOICE OF TRIGGERING METHOD IS IMPORTANT.
Read and understand section titled "METHODS OF OPERATION." (page 12)
•
6. DO NOT EXCEED 100 psi. (6.9 bar 7.0 kgf/cm2)
7. ALWAYS WEAR EAR AND HEAD PROTECTION.
Always wear ear protection to protect your ears from loud noise.
•
Always wear head protection conforming to ANSI Z89.1-1986 protect your head from flying objects.
•
All manuals and user guides at all-guides.com
SAFTEY
READ ALL INSTRUCTIONS
DANGER
When operating the Stapler, always wear eye safety glasses with side shields, and make sure others in the
work area wear safety glasses, too.
Safety glasses must conform to the requirements of American National Standards Institute, ANSI Z87.1
and provide protection against flying particles both from the front and side.
The employer must enforce the use of safety glasses by the Stapler operator and others in work area.
Never use oxygen, combustible gases or any other bottled gases as a power source for the Stapler.
Use of the above gases is dangerous, as the Stapler will explode.
Use only clean, dry, regulated compressed air.
WARNING
Always assume the Stapler contains fasteners.
Never point the Stapler at yourself, toward yourself or others whether it contains fasteners or not.
If fasteners are mistakenly driven, it can lead to severe injuries.
Never engage in horseplay with the Stapler.
Respect the Stapler as a working implement.
Do not exceed maximum recommended air pressure 100 psi
•
(6.9 bar 7.0 kgf/cm2)
Never connect the Stapler to pressure which potentially exceeds 200 psi
•
(13.7 bar 14 kgf/cm2) as the Stapler can burst.
4
English