Filter Replacement; Particle Sensor Cleaning - HoMedics TOTALCLEAN AP-T45WT-EU Instruction Manual

FILTER REPLACEMENT

REPLACE FILTER LIGHT
The replace filter light illuminates when it is time to replace the
HEPA-type filter based on the air purifier's hours of use.
REPLACING THE HEPA-TYPE FILTER
For optimal performance, replace every 12 months under normal
usage conditions.
1. Unplug the air purifier. Pull
the indents on each side of the
grille cover.
3. Pull the tabs to remove the
old filter.
5. Place the tabs at the bottom
of the grille cover into the
base of the air purifier. Gently
push the grille cover until it
snaps into place.
UV-C BULB REPLACEMENT
REPLACING THE UV-C BULB
The UV-C bulb is designed to last for approximately 10,000 hours
of use. The UV-C button on the control panel will flash RED when
the UV-C bulb burns out and needs to be replaced. The UV-C button
will change to blue once the bulb has been replaced.
2. Remove the grille cover and
set aside.
4. With the filter tabs facing
outward, insert the new
HEPA-type filter.
6. Plug the power cord into a
standard AC outlet and press
the power button Press
and hold the ioniser ION
button for 3 seconds to reset
the indicator.
NOTE: The air purifier will continue to operate without the UV-C
function when the UV-C bulb burns out.
CAUTION: Do not operate the air purifier without the
protective UV-C bulb cover.
Unplug the power cord before servicing or replacing the
UV-C bulb.
1. Unplug the air purifier
and remove the HEPA-type
filter. Using a Phillips-head
screwdriver (not included),
unscrew the 2 screws
located on the UV-C bulb c
over.
3. Gently push from the
sides and rotate the UV-C
bulb to remove.
NOTE: The UV-C bulb contains mercury (Hg).

PARTICLE SENSOR CLEANING

NOTE: The particle sensor needs to be vacuumed monthly under
normal usage.
1. Unplug the air purifier.
2. Remove the particle sensor door.
3. Vacuum the particle sensor using the brush attachment of your
vacuum cleaner.
4. Reattach the particle sensor door.
5. Plug the power cord into a household electrical outlet.
GB
6 I
2. Remove the cover to expose
the UV-C bulb.
4. Remove and replace the
UV-C bulb. Re-install the UV-C
bulb cover, HEPA-type filter,
and grille cover.