Ieee Standards; Agency Compliance; Usa Federal Communications Commission (Fcc) Statement - Dell S3100 Series Installation Manual

IEEE Standards

The system complies with the following IEEE standards.
● 802.1AB LLDP
● 802.1ag Connectivity fault Management
● 802.1D Bridging, STP
● 802.1p L2 Prioritization
● 802.1Q VLAN Tagging, Double VLAN Tagging, GVRP
● 802.1s MSTP
● 802.1w RSTP
● 802.3ab Gigabit Ethernet (1000BASE-T)
● 802.3ac Frame Extensions for VLAN Tagging
● 802.3ad Link Aggregation with LACP
● 802.3ae 10 Gigabit Ethernet (10GBASE-X)
● 802.3az Energy Efficient Ethernet
● 802.3ba 40 Gigabit Ethernet (40GBase-SR4, 40GBase-CR4) on optical ports
● 802.3u Fast Ethernet (100BASE-TX)
● 802.3x Flow Control
● 802.3z Gigabit Ethernet (1000BASE-X)
● ANSI/TIA-1057 (LLDP-MED)
● Dell Networking (PVST+)
● MTU (12,000 bytes)

Agency Compliance

WARNING: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel
ground strap when handling the system and its components.
USA Federal Communications Commission (FCC)
Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and
used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures
necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell Networking is
not responsible for any radio or television interference caused by using other than recommended cables and connectors or by
unauthorized changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority
to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Figure 33. Canadian Department of Communication Statement
S3100 Series Technical Specifications 41