Changing The Initial Settings Of The Recorded Song; Deleting Recorded Data - Yamaha ARIUS YDP-165 Owner's Manual

Changing the Initial Settings of the Recorded Song

The settings of the following parameters can be changed after the Record operation is completed.
• For individual Parts: Voice, Volume balance (Dual/Duo), Reverb Depth
• For the entire Song: Tempo, Reverb Type
1.
Make settings for the above parameters as desired.
2.
While holding down [REC], press the desired Part ([+R] or
[−L]) to engage Record Ready mode.
The [REC], [PLAY] and selected Part lamps flash.
In this status, do not press [PLAY] again or any key. Otherwise, the originally
recorded performance data will be deleted.
3.
While holding down [REC], press [PLAY] to exit from
Record Ready mode.
The [REC], [PLAY], [+R] and [−L] lamps flash. After the Save operation is
completed, the lamps will turn off, indicating that the operation has been
completed.
Confirm the setting by pressing [PLAY] to play the Song.

Deleting Recorded Data

To delete the entire Song:
1.
While holding down [REC], press [DEMO/SONG].
The [REC] and [PLAY] lamps flash alternately.
To cancel the operation, press [REC].
2.
Press [PLAY] to delete the data of the entire Song.
The [REC], [PLAY], [+R] and [−L] lamps flash.
After the operation is completed, all lamps turn off.
To delete a specific Part:
1.
While holding down [REC], press [+R] or [−L] (depending
on the Part you want to delete) to engage Record Ready
mode.
The [REC], [PLAY] and selected Part ([+R] or [−L]) lamps flash.
2.
Press [PLAY] to start recording without playing the
keyboard.
The selected Part ([+R] or [−L]) lamp flashes.
3.
Press [REC] or [PLAY] to stop recording.
All data recorded for the selected Part will be deleted, and the lamp turns off.
Recording Your Performance
NOTE
If a User Song has not been
recorded to the instrument, the
[REC] and [PLAY] lamps flash
quickly for about three
seconds.
YDP-165, YDP-145, YDP-S55, YDP-S35 Owner's Manual
29