Changing the Initial Settings of the Recorded Song
The settings of the following parameters can be changed after the Record operation is completed.
• For individual Parts: Voice, Volume balance (Dual/Duo), Reverb Depth, Damper Resonance
• For the entire Song: Tempo, Reverb Type
Make the settings of the above parameters.
While holding down [REC], press the desired Part button to
engage Record Ready mode.
After a while, the [REC] lamp and the selected Part lamp will flash at the current
In this status, do not press [PLAY] again or any key. Otherwise, the originally
recorded performance data will be deleted.
Press [REC] and [PLAY] to exit from Record Ready mode.
The [REC], [PLAY], [+R] and [–L] lamps flash. After the Save operation is
completed, the lamps will turn off, indicating that the operation has been
Confirm the setting by playing the Song.
Deleting Recorded Data
To delete the entire Song:
While holding down [REC], press [DEMO/SONG].
The [+R] and [–L] lamps flash.
To exit from this status, press [–L].
Press [+R] to delete the data of the entire Song.
The [REC], [PLAY], [+R] and [–L] lamps flash.
After the operation is completed, all lamps turn off.
To delete a specific Part:
While holding down [REC], press [+R] or [–L] (depending
on the Part you want to delete) to engage Record Ready
The [REC] and the selected Part ([+R] or [–L]) lamps flash.
Press [PLAY] to start recording without playing the
The selected Part ([+R] or [–L]) lamp flashes.
Press [REC] or [PLAY] to stop recording.
All data recorded for the selected Part will be deleted, and the lamp turns off.
Recording Your Performance
YDP-S52 Owner's Manual