Advertisement
Care and maintenance
•
Before cleaning the air purifier, always
turn OFF and unplug the unit.
•
Clean the exterior surface with a clean,
damp cloth.
•
The top air outlet vent can be cleaned of
dust with a small, soft brush.
•
If you would like to clean the inside of
your filter compartment, ONLY use a
dry, soft cloth to wipe it down.
WARNING: Do not allow moisture to come
into contact with the main housing of the
air purifier. NEVER use detergents, glass
cleaner, furniture polish, paint thinner, or
other household solvents to clean any part
of the appliance.
How to replace the True HEPA filter
It is recommended to replace the 3-in-
1 True HEPA filter every 12 months
depending on usage.
1. The filter replacement indicator light
will illuminate red when it is time to
replace the filter.
2. Turn OFF and unplug the air purifier.
3. Locate the filter cover on the bottom of
the unit.
4. Rotate the knob counterclockwise to
remove the cover and expose the filter
(Figure 1-2 on the previous page).
5. Remove and discard the filter and
re-insert a new filter (Figure 3 on the
previous page).
6. Re-align the filter cover and turn the
knob clockwise to close.
6
HOW TO CLEAN THE FABRIC
FILTER
It is recommended to clean the outer fabric
filter every 3 months or when dust appears.
1. Turn the unit OFF and unplug.
2. Gently vacuum the dust from the fabric
or wipe clean with a damp cloth.
7. Plug the unit and turn the power ON.
8. To reset the filter status on the
air purifier, press & hold the filter
replacement button
for 3 seconds.
The filter icon
will turn off.
Information on where to purchase
replacement filters can be found on our
website at www.sunbeam.com.au.
WARNING: Only use the original Sunbeam
filter model SAPF360D specially intended
for this appliance. Do not use any other
filters.
How to Replace the UV Light Bulb
It is recommended to replace the UV light
bulb every 12 months.
CAUTION: The UV bulb has a maximum
wattage of 3.5 Watts.
WARNING: Always disconnect the power
before replacing the UV bulb or servicing.
1. Turn the unit OFF and unplug the air
purifier.
2. Locate the filter cover on the bottom of
the unit.
3. Rotate the knob counterclockwise to
remove the cover and expose the filter
(Figure 1-2).
4. Remove the filter and set aside
(Figure 3).
5. Remove the UV bulb housing by using
a screwdriver to remove the four screws
(Figure 4-5).
Figure 1
Figure 2
Figure 3
6. Carefully remove the UV bulb by
rotating the bulb counterclockwise
(Figure 6). Discard the old UV bulb.
7. Install the new UV bulb by rotating the
bulb clockwise.
8. Re-install the UV bulb housing by using
a screwdriver to secure the four screws.
9. Re-insert the filter.
10. Re-align the filter cover and turn the
knob clockwise to close.
WARNING: Only use the original Sunbeam
UV Bulb model specially intended for this
appliance.
Do not use any other bulbs. Contact
Sunbeam Customer Care for ordering
replacement parts.
Figure 4
Figure 5
Figure 6
7
Advertisement
