Troubleshooting Guide; Inflation Option - Intex FastFill I637USB Owner's Manual

INFlATION OPTION

If electrical power is not available, a conventional foot, manual, or battery-operated air
pump can be used by connecting it to the manual inflation port located inside the line cord
compartment. Do not use high-pressure air compressors. See Fig (15). Follow these steps:
1. Open line cord compartment cover and locate the
manual inflation port.
2. Make sure the control dial of the internal electric
pump is still in the off mark (
3. Remove the cap from the manual inflation port and
insert the nozzle of the pump into the port. Inflate the
airbed to desired firmness.
NOTE: Do not overinflate. The firmness should be
approximately the same as the level achieved with the internal electric pump.
4. Remove nozzle from manual inflation port and close the cap and the line cord cover.
PROBlEM
Air pump does
• The external power adapter/
not work
supply output is not correct.
• Pump running continuously for
30 minutes, motor protection
system activated.
• Pump continuously connected
to a portable USB charger and
idled, hence the portable USB
charger is in rest mode.
Airbed not fully
• The external power adapter/
inflated after
supply output amperage (A) is
5 - 7 minutes
less than 2A.
of inflation
• The manual inflation port cap is
not securely closed.
Air leaking from
• The control dial is not in the off
the pump panel
mark (
or compartment
• The manual inflation port cap is
cover
not securely closed.
SAVE THESE INSTRUCTIONS
(37IO) I637USB ELECTRIC PUMP ENGLISH 4.875" X 7.25" 06/19/2021
) position.

TROUBlESHOOTINg gUIdE

CAUSE
) position.
Page 5
SOlUTION
• Make sure the output of the external power
adapter, such as USB Wall Charger, Portable
USB Charger, 12V Car Charger or USB Port
is rated 5V / 2A or more. See "INFLATION"
section.
• Switch off and disconnect the line cord from
the power adapter/ supply. Let the pump rest
for 1 minute before restarting.
• Disconnect and reconnect the USB cable to
the portable USB charger.
• Make sure the output of the external power
adapter, such as USB Wall Charger, Portable
USB Charger, 12V Car Charger or USB Port
is rated 5V / 2A or more. See "INFLATION"
section.
• Push the cap firmly into the manual inflation
port.
• Turn the control dial to the off mark (
position after inflation is completed.
• Push the cap firmly into the manual inflation
port.
37
English
IO
FIg (15)
)