Troubleshooting Guide - Intex QuickFill AP637 Owner's Manual

PROBLEM
Air pump does • Pump running continuously for
not work 30 minutes, motor protection
system activated.
• The battery power is too low.
Item not fully • Item to be inflated is too big.
inflated after • Item inflation air valve not fully
6-7 minutes pushed open during inflation.
of inflation • The external power adapter/
supply output amperage (A) is
less than 2A.
WARNING: Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
READ AND SAVE THESE INSTRUCTIONS
(50PO) AP637 MINI USB PUMP ENGLISH 3.75" X 3.75" 06/28/2023

TROUBLESHOOTING GUIDE

CAUSE
• Switch off and disconnect the USB cable from the
pump. Let the pump rest for 10 minutes before
restarting.
• Recharge the battery.
• Use another air pump with a larger air flow capacity.
• Use the pointed nozzle to fully push open the air
valve during inflation.
• Make sure the output of the external power adapter,
such as USB Wall Charger, Portable USB Charger,
12V Car Charger or USB Port is rated 5V / 2A or
more.
Page 6
SOLUTION
50
PO