Troubleshooting Your Qtac; The Pump Engine Will Not Start; The Pump Will Not Build Water Pressure - QTAC 85C Owner's Manual

TROUBLESHOOTING YOUR QTAC

The Pump Engine Will Not Start

• Ensure that the engine switch is in the "ON" position.
•
Ensure that the engine throttle is open slightly from the idle position.
•
Adjust the choke. If the engine is cold, full choke will likely be needed.
•
Ensure that fuel exists in the fuel tank, and the shut-off valve is on.
• For further troubleshooting information, see the Honda Owner's Manual

The Pump Will Not Build Water Pressure

•
Ensure that the pump engine is running and operating at a sufficient speed.
•
Ensure that there is sufficient water in the water tank. There should be enough
water in the water tank so that the water level is visible in the water tank site
gauge (Figure 1, Item 5)
•
Unless the draft hose kit is in use, ensure that the Tank to Pump valve is open so
that the pump is drawing water from the water tank and not from the draft port
(Figure 2, Item 4).
•
Ensure that the pump drain port plug is properly tightened and sealed (Figure 2,
Item 7).
•
Ensure that the pump is properly primed with water. Open the primer valve
(Figure 2, Item 6), and operate the Guzzler hand primer (Figure 2, Item 9) until
water flows back into the tank.
•
Check the piping on the suction side of the pump to ensure that no air leaks are
present.
•
For further troubleshooting information, see the pump Instruction Manual.
Page | 18