Table of Contents
Advertisement
GENERAL SAFETY WARNINGS
Electrical safety
1. The connector plug for the power tool must fit in the
socket. The plug must not be modified in any way. Do
not use any adapter plugs in combination with power
tools with protective earthing. Unmodified plugs and
matching outlets will reduce the risk of electric shock.
2. Avoid body contact with earthed surfaces like
pipes, heaters, stoves and refrigerators. There is an
increased risk of electric shock if your body is earthed
or grounded.
3. Keep power tools away from rain or moisture. Water
entering a power tool will increase the risk of electric
shock.
4. Do not use the cord for improper purposes such as
for carrying the power tool, for hanging it up or for
pulling or unplugging it from the socket. Keep cord
away from heat, oil, sharp edges and moving parts.
Damaged or entangled cords increase the risk of
electric shock.
5. When operating a power tool outdoors, use only
extension cords that are suitable for outdoor use. Use
of a cord suitable for outdoor use reduces the risk of
electric shock.
6. If operating the power tool in a damp environment
cannot be avoided, use a RCD. Use of an RCD
reduces the risk of electric shock.
8
GENERAL SAFETY WARNINGS
Safety of persons
1. Be careful, pay attention to what you are doing and
approach work with a power tool in a reasonable
manner. Do not use any power tool if you are tired or
under the influence of drugs, alcohol or medication.
A moment of inattention while operating power tools
may result in serious personal injury.
2. Wear personal protective gear and always wear safety
glasses. Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing protection
used for appropriate conditions will reduce personal
injuries.
3. Avoid accidentally activating the device. Make sure
that the power tool is turned off before you connect it
to the power supply and/or the rechargeable battery,
pick it up or carry it. Carrying power tools with your
finger on the switch or connecting the power tool to a
power supply while the switch is set to "on" may lead
to accidents.
4. Remove all adjusting tools or spanners before you
switch the power tool on. A wrench or a key left
attached to a rotating part of the power tool may
result in personal injury.
5. Avoid an abnormal posture. Keep proper footing and
balance at all times. This enables better control of the
power tool in unexpected situations.
6. Wear suitable clothing. Do not wear loose clothing
or jewellery. Keep your hair and clothing away from
moving parts. Loose clothes, jewellery or long hair
can be caught in moving parts.
9
Advertisement
Table of Contents
