Error Codes; Maintenance; Battery - Juiced Bikes RIPRACER Owner's Manual

OPERATION - ADVANCED LCD

ERROR CODES

The electronics system has some ability to self-diagnose and
report a limited set of faults. The faults will appear on the
screen as error codes. The chart below explains the meaning of
each error code.
ADVANCED MATRIX DISPLAY - ERROR CODE CHART
Error
Error
Code
Open Throttle Throttle has not returned to the start position on start-up. Check to see if the throttle can return to the start position or if there
4
Fault is something blocking the throttle unit.
5 Throttle Fault Throttle may be damaged. Check the throttle or throttle cable for damage.
Low Voltage The battery voltage is too low to operate. Incorrect battery was used on the bike. The battery is in sleep mode or not
6
Protection functioning correctly.
Over Voltage The battery voltage is too high to operate. Incorrect battery was used on the bike.
7
Protection Check to be sure that the correct battery is being used on the bike.
Motor Hall At least one of the motor's hall sensor wires have been disconnected or damaged.
8
Signal Fault Disconnect and reconnect the motor cable.
Motor Phase
9 At least one of the motor's phase wires has been disconnected or damaged.
Line Fault
High
The controller has reached the highest allowable temperature.
10 Temperature
Allow the controller to cool down before using the e-bike again.
Fault
Temperature
11 The controller's temperature sensor has become disconnected or damaged. Contact technical support.
Sensor Fault
Current Sensor
12 The controller's current sensor has become disconnected or damaged. Contact technical support.
Fault
Speed Sensor
21 The speed sensor has become disconnected or damaged. Contact technical support.
Fault
Communication
30 Poor connection between the controller and the display. Check all cable connectors. Check for corrosion damage.
Fault
34
Notes
JBP-RR-MANUAL | © 2022 JUICED BIKES

BATTERY

NOTICE
Failure to properly charge, store or use the battery will void the warranty. Use caution
when handeling the battery pack as it is heavy.
REMOVING THE BATTERY PACK
You can remove the battery pack from the bike. Remove the
battery pack when storing or transporting the e-bike.
Fig. 28 - Removing Battery Pack
1. Turn off the bicycle.
2. Stand on the left side of the bicycle. Locate the keyhole on
JBP-RR-MANUAL | © 2022 JUICED BIKES

MAINTENANCE

6
the frame near the top of the battery pack.
3. Insert the key into the battery pack lock keyhole.
4. Turn the key counterclockwise and hold.
5. Pull the upper portion of the battery pack toward you.
6. Let go of the key from the battery pack lock.
7. Pivot the battery pack sideways and lift it away from
the bike.
CHARGING THE BATTERY PACK
The charger can become warm during charging.
WARNING
!
Read and understand all instructions. Failure to follow all
instructions listed below could result in death or serious
personal injury.
Use only the charger supplied with the bicycle. Do not
•
charge the battery pack with any charger that is not
supplied or approved to charge the bike.
Do not place anything over the charger while it is charging.
•
Do not use the charger in damp or wet locations.
•
Do not cover the body of the charger when charging.
•
Do not drop the charger or subject it to high vibration. Do
•
not use a charger that has been dropped.
35