GAGGLE Parade 6 Manual page 10

Attach roof:
NOTE: Foundations recommends 2 people
are needed for this step.
Place assembled roof (B) bottom tabs into
slots on top of Gaggle Buggy (A) that are
open after roof pockets were removed.
In 4 places, Place shoulder screw (U)
through cap nut washer (V) and plain
washer (W) sequentially as shown. Finger
tighten bolts.
After all 4 bolts with washers have been
inserted through roof use Allen Wrench (T)
to snug bolts but do not overtighten.
Snap on new cap nut (S).
See Figure 11.
Stroller cleaning:
• Stroller may be cleaned with a mild solution of soap and water.
• Rinse well with clear water to remove soap solution.
• Never use cleaning agents that may contain chemicals hazardous to children.
• Do not use cleaners with abrasives as this may scratch roof surface.
• Harness straps can be cleaned with soap and water and should be wiped or
air dried after cleaning.
Gaggle Parade 6 technical repair manual is available through the Gaggle Strollers web-
site. For assistance call or write:
Roof Assembly Step 3
Stroller Maintenance and Care
Medina, Ohio, 44256, USA
Telephone: 877.716.2757 (U.S.Only) or 330.722.5033
www.gagglestrollers.com
S
U
Gaggle Strollers
5216 Portside Dr.
Fax: 330.722.5037
9
B
V
W
A
Figure 11
AB20008A_G7