universalblue UBT2500-20 Instruction Manual page 29

3. Install the supply socket in the wall. The requirements for the
socket are as follows:250V/10A, single phase, three electrodes.
It is recommended to placed the socket on the right above the
heater. The height of the socket to the ground shall not be less
than 1.8m (see Fig.3).
4. If the bathroom is too small, the heater can be installed at
another
However, in order to reduce the pipeline heat losses, the
installation position of the heater shall be closed to the location
shall be as near as possible to the heater.
PIPELINES CONNECTION
1. The dimension of each pipe part is G1/2" ; The massive pressure
of inlet should use Pa as the unit; The minimum pressure of inlet
should use Pa as the unit.
place without sun-scorched and rain-drenched.
29