Advertisement
STEP 7
Direction of cable management and accessory assembly.
Holes for cable
management.
STEP 8
Put back the cooling pad and fasten the screws by using a
4mm Allen key.
4mm
6
Storage for
cables and
adapters.
To avoid
fingers getting
caught/hurt,
please slide
the mouse tray
by using the
palm.
Place the laptop in the compartment and place back the work
surface. Please notice the work surface must be locked and
the latch must be pushed forward before moving this cart.
Lock
Open
ADJUSTMENT AND OPERATION
In case of cart damage, do not adjust the lift mechanism with an empty cart, since this may cause the work surface to
rise too quickly.
Notice:
Make sure to put a hand on both sides of the work surface while releasing the brake to higher or lower the work surface,
as shown in the figure. Do not push the center of the work surface to lower the height. When raising the work surface,
use two hands to slightly lift the surface if it remains motionless.
250mm
Release brake to
adjust the height.
7
Advertisement
