MAGIS HERCULES PRO
9
If the produced condensate is drained through the drain pipe,
connect the standard supplied drain fitting (1) in one of the
drainage holes on the bottom of the appliance and close the
other holes with drain plugs (see drawings below) and use the
drain pipe (16 mm internal diameter) commercially available so
that it conveys the water to the desired location. In the event of
installation in very cold zones or zones subject to heavy snow
where the condensate drain pipe can freeze, take the necessary
precautions to keep the drainage holes or the condensate drain
pipe free.
N.B.: If the water produced by the unit is not properly drained,
the performance of the entire system will suffer a negative impact
and the system itself could be damaged.
AUDAX PRO 4 V2
AUDAX PRO 6 V2
Ø20 drainage hole (in 5 positions)
Air flow side
DRAIN HOLES AND CONDENSATE DRAIN
Drainage fitting (1)
AUDAX PRO 9 V2
UE AUDAX PRO 12-14-16 V2
UE AUDAX PRO 12-14-16 V2 T
Ø20 drainage hole (in 4 positions)
Air flow side
30 mm
13