Table of Contents
Advertisement
Ending the programming
mode prematurely :
Setting the
watering programs :
1.
2.
3.
4.
5.
6.
20
Watering Programs (Channel Key)
Prerequisite : The date and time have been set.
To give you a better overview, we recommend that before starting
to enter the watering data you enter the data for your valves into
the watering plan in the appendix of these operating instructions.
You can save 3 watering programs for each channel (a maximum
of 3 programs x 4 (Art. 1283) / 6 (Art. 1284) channels = 12 (1283) /
18 (1284) programs).
You can exit the programming mode prematurely at any time.
v Press the Channel key twice.
The main level is displayed.
PLEASE NOTE !
If two programs overlap on one channel, this results in
the total watering duration being less than planned.
If two programs overlap on different channels, the water
pressure may drop to an extent such that watering is
inadequate or the pop-up sprinklers fail to extend.
V Make sure that the watering times of the programs do
not overlap.
Selecting the channel and program memory location :
1. Press the Channel key.
SELECT CHANNEL
and the channel flash.
You can end the programming mode at any time by pressing the
Channel key.
2. Select the channel using the ▲-▼ keys (e.g. channel 2) and
confirm by pressing the OK key.
Channel appears on the display (e.g. 2 ) and
Select Program and the program memory location flash.
3. Select the program memory location using the ▲-▼ keys
(e.g. program memory location 3) and confirm by pressing
the OK key.
Start Time and the hours for the watering start time flash.
Setting the watering start time :
4. Select the hours for the watering start time using the ▲-▼ keys
16
(e.g.
) and confirm by pressing the OK key.
Start Time and the minutes for the watering start time flash.
5. Select the minutes for the watering start time using the ▲-▼
keys (e.g.
30
) and confirm by pressing the OK key.
Run Time and the hours for watering duration flash.
Setting the watering duration :
(This always corresponds to 100 % run-time)
6. Select the hours for watering duration using the ▲-▼ keys (e.g.
1
hour) and confirm by pressing the OK key.
Run Time and the minutes for watering duration flash.
Advertisement
Table of Contents
