New transducer and baffle designs have realized improvements in diffraction, which vastly improves the stereo imaging of a speaker. This new series embodies all that ENERGY Loudspeakers has tried to accomplish in our 20+ years of loudspeaker design and manufacturing.
Bi-Amplification Wiring Instructions ™ Connecting the Veritas 2.0R Rear Channel Surround Speaker Connection of V2.0R Bi-Wiring and Bi-Amplification Adjusting the V2.0R Rear Channel speaker Mode Switch Level Control How to Set Up the Controls Specification Page Safety Concerns Care of Finish...
Study your room carefully and decide whether the side walls are best, or the rear walls. The goal is to try to position the speaker system around you, so that you are “surrounded” by the information from the different channels. The choice of rear speaker placement depends greatly on the position of the listeners.
When deciding on the center channel speaker placement, it is important to place the speaker so that the edge of the speakers' front is at the edge of the shelf or stand supporting it. Unwanted diffraction would occur if the...
Place the speaker on the stand. Using the hardware supplied with the stand, attach the speaker to it by inserting the two Philips head bolts from the bottom of the stands' top plate into the insert on the speakers' bottom. Hand tighten only! The front bolt goes through the front hole on the top plate, inserted from the bottom.
™ Series speakers are quite similar to any standard speaker with bi-wire/ bi-amp options. There are 4 Gold Plated Connectors on the rear of the speaker enclosure, and although they look unique, they are traditional in function. TRADITIONAL CONNECTION METHOD...
FIGURE 5 Connecting the Veritas 2.0R Rear Channel Surround Speaker NOTE: The four connectors on the V2.0R speaker differ slightly from the other models. PLEASE READ THIS SECTION CAREFULLY. Under normal circumstances, you will never have the need to bi-wire, or bi-amplify the rear channel speakers in a typical home theater system.
There are two controls on the “Soundfield Management” Control panel which is located behind the speaker grill on either the left or right side. The speakers are mirror imaged. See Figure 7.
OWNERS MANUAL HOW TO SET UP THE CONTROLS The following chart (Diagram “B”) will explain how to set up the controls on the Soundfield Management System. But follow these instructions first. The first thing you must do is measure two distances. First measure the distance between the listening position and one of the front speakers (D1 on Diagram “A”), then measure the distance between...
See Figure 8. FIGURE 8 The V2.3 and V2.4 floor standing models however have four metal spikes included, with five insert locations. Use the spikes only on a carpeted surface as they can damage product to hardwood floors.
WARRANTY Limited Warranty Policy in the United States and Canada ENERGY ® LOUDSPEAKERS warrants this product to the retail purchaser against any failure resulting from original manufacturing defects in workmanship or materials. The warranty is in effect for a period of 5 years from date of purchase from an authorized ENERGY only if the original dated bill of sale is presented when service is required.
Page 14
Energy Loudspeakers, a Division of Audio Products International Corp. 3641 McNicoll Avenue, Scarborough, Ontario, Canada M1X 1G5 416-321-1800 Fax 416-321-1500 www.energy-speakers.com Printed in Canada 7AI//EV201...