Saxby Lighting Cosmo Instruction Leaflet

Commissioning
• Replace the cover on the terminal block.
• Lift the product into place and align the screw holes
up with the holes on the bracket.
Fitting/replacing bulbs
• When changing a bulb, always switch off at the
mains and allow the bulb to cool before handling.
Used bulbs should not be disposed of with household
waste. Please recycle where facilities exist.
• Always use the correct type and wattage bulb. Using
the incorrect wattage bulb will damage the product.
• Use a soft cloth to handle bulbs, avoid directly
touching the bulbs as this will shorten their life.
• Unscrew the glass shades anticlockwise. Pull the bulb
out to remove.
We recommend cleaning with a soft dry cloth.
Do not use solvents or abrasive cleaners as these could
damage the finish.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This bulb is protected by a glass shade. This part must be replaced immediately should the glass
shade become cracked or damaged. This fitting must not be used without the glass shade in place.
Replace Cracked
Shade
www.saxbylighting.com
• Using the supplied allen key, tighten the screws to
secure. Take care not to trap any wiring.
• Replace fuse or circuit breaker and switch on. Your
light is now ready for use.
• Push the new bulb in. Replace the glass by gently
screwing on.
18W G9
Mains Halogen
Glass parts – Remove and wash in warm water or just
use a damp cloth. Do not use abrasive materials as
these will damage the finish.
Iss.3 17122013
Saxby Lighting Ltd. BH23 3PE
Instruction leaflet
Cosmo Spotlight
39616