Kicker 47KSMT25 Installation Manual

Kicker 47KSMT25 Installation Manual

Advertisement

PARTS LIST

ITEM NO.
1
47KSMT25 POD ASSEMBLY WITH NUT AND WASHER
2
BUTT CONNECTOR
3
47KSMT25 CROSSOVER
4
CAPACITOR
EOP2021-CS4
REV-A.3
DESCRIPTION
47KSMT25 Installation Guide
QTY.
2
4
2
2
7/6/2021
Page 1 of 8

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 47KSMT25 and is the answer not in the manual?

Questions and answers

Summary of Contents for Kicker 47KSMT25

  • Page 1 PARTS LIST ITEM NO. DESCRIPTION QTY. 47KSMT25 POD ASSEMBLY WITH NUT AND WASHER BUTT CONNECTOR 47KSMT25 CROSSOVER CAPACITOR EOP2021-CS4 7/6/2021 REV-A.3 47KSMT25 Installation Guide Page 1 of 8...
  • Page 2 The Kicker KSMT25 pod provides a mid and tweeter with optimized adjustability. The pod can be mounted to almost any surface where a hole can be drilled. Not only does the entire pod assembly pivot, lean, and rotate on the ball and socket mounting stud - the tweeter also has approximately 260 degrees of planetary rotation around the mid to provide desired orientation.
  • Page 3 Using a 2.5mm allen wrench, loosen (do not remove) the bolt retaining the tweeter to the mid. 2. Rotate the tweeter to the desired location and retighten the bolt. Replace the decorative plug. EOP2021-CS4 7/6/2021 REV-A.3 47KSMT25 Installation Guide Page 3 of 8...
  • Page 4 Choose a mounting surface that can be accessed from both side as a wing nut must be installed on the mounting stud to retain the pod in its location. 1. Drill a 9/16” hole in the desired mounting location. EOP2021-CS4 7/6/2021 REV-A.3 47KSMT25 Installation Guide Page 4 of 8...
  • Page 5 Always disconnect the vehicle’s power source before making wire connections. Kicker supplies crossovers with KSMT25 to optimize the sound of the pod’s speakers. The KSMT25 crossover is terminated so that it will only connect to the KSMT25 assembly.
  • Page 6 1. Connect the crossover terminals and receptacles to their respective mating connector on the KSMT25 pod assembly. The terminals on the 47KSMT25 crossover are all different sizes and types to prevent incorrect connection. Also, the crossover wire colors match the pod assembly wire colors.
  • Page 7 3. Connect the crossover input to the outputs of the head unit or amplifier using the supplied butt connectors. The positive lead is the wire with gray insulation labeled with a “plus” symbol. The negative lead has gray insulation with a black stripe on it. EOP2021-CS4 7/6/2021 REV-A.3 47KSMT25 Installation Guide Page 7 of 8...
  • Page 8 KSMT25 to play above 400 hertz at 12db per octave slope or greater. If an active crossover is not used, solder the supplied capacitors to the positive inputs of the 47KSMT25 crossovers. Cover solder joints with heat shrink. SUPPLIED CAPACITOR EOP2021-CS4 7/6/2021 REV-A.3...

Table of Contents