Wiring Diagram; Cleaning And Maintenance - Sylvania UltraLED Series Installation Manual

Wiring Diagram

This fixture is compatible with 0-10V output dimming controls (please reference Dimmable Compatibility List LEDLUM012).
To get to 0% light output (OFF) it is necessary to switch the input power to the LED drivers.
Connect wall dimmer to dimming wires on driver. (See Wiring Diagram).
The Yellow wire is a 12-volt DC auxiliary power output for optional accessories – cap if not in use.

CLEANING AND MAINTENANCE

• To maintain the fixture efficacy occasional cleaning of the outer lens surface may be needed.
• Use a mild soap or detergent, which is essentially neutral pH (pH approximately 6 to 8), nonabrasive, and
which contains no chlorinated or aromatic hydrocarbons.
• Wash thoroughly, using a soft cloth.
• Rinse with clean, cold water and wipe dry.
TROUBLE SHOOTING CHECKLIST: If luminaire does not work
– Check your power source.
– Check electrical connections.
Wiring Diagram