Safety Precautions; Installation; Surface Mounting - Sylvania UltraLED Series Installation Manual

DIMENSIONS:
Competitor Product Comparison

SAFETY PRECAUTIONS:

IMPORTANT: READ CAREFULLY BEFORE INSTALLING THE FIXTURE. RETAIN FOR FUTURE REFERENCE.
GENERAL: Upon receipt of the fixture, thoroughly inspect for any freight damage which should be brought to the attention of the delivery carrier.
TO AVOID ELECTRIC SHOCK OR COMPONENT DAMAGE DISCONNECT POWER BEFORE ATTEMPTING INSTALLATION OR SERVICING

INSTALLATION:

1: Fixture Preparation
A. Carefully remove the lens from the housing one side at a time.
B. Remove the 2 screws from the ends of the driver cover and discard. Remove the driver cover by squeezing it next to the notches at both
ends and at the center (6 notches for 4 ft model / 4 notches for 2 ft model) to release the notches along both sides (Fig 1).

2: Surface Mounting

A. If mounting directly to a surface, temporarily place fixture in the desired mounting location over the wiring junction box and mark the
location of the 4 mounting holes (Fig. 2). Remove the fixture and predrill the mounting holes to accept the surface mounting hardware
(supplied by others).
B. Pull the supply wires from the junction box through the center access hole of the fixture housing (Fig. 1).
C. If wiring through the end of the fixture, drill through the outer plastic end cap at the location of the wiring access hole in the inner metal
end plate (Fig. 1).
D. Secure the housing to the junction box or mount the housing directly to the mounting surface using the holes drilled in step 3. Use the
appropriate mounting hardware (supplied by others) for surface mounting.
E. Connect the supply wires to the fixture according to the National Electric Code and all applicable State and Local codes.
F. Once the connections are made, push all the wires neatly down the center of the fixture and replace the driver cover by sliding it under
the notches along one side and squeezing the cover to slide it under the notches on the opposite side. Be careful not to pinch the wires.
G. Hook the lens to one side of the housing and then snap the lens into place on the opposite side (Fig. 3).
H. Installation is now complete. Turn on the power at circuit breaker or fuse box then turn on the light switch to power the fixture.
Confidential – for internal use only