Suspension Mounting - Sylvania UltraLED Series Installation Manual

INSTALLATION (cont.):
Confidential – for internal use only
Competitor Product Comparison
Fig. 2 Mounting Holes
Fig. 3

3: Suspension Mounting

A. Attach suspension cable or chain (supplied by others) to the mounting surface at the desired locations.
B. Attach the suspension cable to the fixture through the appropriate holes at each end and level the fixture at the desired height (Fig 4).
-OR-
C. Attach the chain to the supplied V-hanger and hook the V-hangers through the appropriate holes at each end of the fixture (Fig 5).
D. If row mounting is desired, drill through the outer plastic end caps of adjoining fixtures at the location of the wiring access hole in the
inner metal end plate (Fig. 1). Attach the optional joiner bracket to the top of abutting fixtures using the four screws provided with the
optional bracket (Fig 6).
E. NOTE: Fixtures must be supported by chain or cable at the ends of each run and on at least one side of each joiner bracket (e.g. 2
fixtures require 3 mounting points, 3 fixtures require 4 mounting points).
F. Connect the supply wires to the fixture according to the National Electric Code and all applicable State and Local codes.
G. Once the connections are made, push all the wires neatly down the center of the fixture and replace the driver cover by sliding it under
the notches along one side and squeezing the cover to slide it under the notches on the opposite side. Be careful not to pinch the wires.
H. Hook the lens to one side of the housing and then snap the lens into place on the opposite side. See Fig. 3.
I. Installation is now complete. Turn on the power at circuit breaker or fuse box then turn on the light switch to power the fixture.
Figure 5
Figure 4
Figure 6