A/B Transient Operations - ITech IT8700 Series User Manual

4.4.4 A/B transient operations

The following will show you how to set operation mode on front panel. Take CC
mode as an example:
1. Power on the electronic load
2. Press
channel 1
CH01 CC OFF
Vdc=0.0000V
Adc=0.0000A
Wdc=0.00W
3. Press
enter the mode selection menu <Mode>, press
mode CC/CV/CR/CW，such as CC，press
CH01
Mode=CC
RANGE=HIGH
Iset=9.000A
4. Press
enter the mode selection menu <Mode>, press
as <low range>, press
CH01
High Range
Low Range
5. Press
1A/uS，press
CH01
Rise Speed Set
= 1.00A/Us
6. Press
slope to be 2A/uS. Press
CH01
Fall Speed Set
7. Press
press
Transition
Level = 10.00A
8. Press
Fig 4-8 toggled mode current waveform
、
key to enter the channel setup menu, press
key to enter range setting <Range>, press
key to enter the rise slope <∫>, such as set the current to be
key to confirm
key to enter the fall slope setting <∫>, such as set the rise
= 2.00A/Us
▼ ▼
key to enter A LEVEL setting <TRANa>，such as 10.00A,
Enter
key to confirm
A
▼ ▼
key to enter A level width setting <Ta>，such as 0.003S，
Copyright © Itech Electronic Co., Ltd.
keys to select the channel to be edited, such as
key to confirm.
key to confirm
Operations introduction
key to
key to select the
key to confirm
key to
key to select, such
44