A.O. Smith aosbath D25A2 User Manual page 2

1. IMPORTANT
Please read this manual carefully before using the product and store it for future reference.
If the user installs the hot water dispenser by themselves or does it by using the self-prepared installation
materials, AOS Bath will not be liable for any adverse effects on the normal operation and service performance of
the system.
The maintenance of this machine requires the use of approved parts and the problems caused by the use of
unauthorized parts (degradation of performance or property damage) are not covered by the manufacturer's
limited warranty. If any components require a change, consumers should contact the local authorised dealer.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge.
Warning : Failure to follow these instructions may lead to risk of fire and could cause property damage and or
personal injury or death
The hot water tank should be installed under-
sink, below the faucet. Do not place the tank on
the countertop or mount it on a wall. The
recommended height distance between the
tank and faucet is 60-80cm .
Maintain a safe distance from the faucet
exhaust and water outlet to prevent
scalding.
Do not disassemble or modify this system.
Do not expose the system to corrosive
substances.
Disconnect the system from power source
during installation and troubleshooting. Do
not touch power plug with wet hands.
Do not use a power supply that exceeds the
specifications of the machine. Ensure the
power cord and socket are in good
condition.
If any abnormality occurs, stop operation of
the system immediately.
Do not cover the appliance with
a cloth or cover the faucet
exhaust hole.
The system must be paired with
a compatible A. O. Smith RO
Water Purifier.
The tank should not be exposed
to water.
Do not place the machine close
to a fire source.
The system must be connected
to a socket with a reliable
grounding.
Use an independent use a
power socket with a minimum
rated current of 10A. Ensure all
connections are secure.