HP Proliant DL140 Maintenance And Service Manual page 32

To reinstall the top cover:
1. Perform steps 1 through 4 of the post-installation procedure.
2. Reinstall the top cover.
Align the cover to the chassis and then slide it towards the front panel to position it into
a.
place.
Once the cover is attached to the chassis, secure it by tightening the captive thumbscrew on
b.
the rear panel.
Reinstalling the top cover
Figure 2
3. Perform steps 6 and 7 of the post-installation procedure.
Drive bay configuration
The server supports three drive bays—two drive bays for 1-inch hard disk drives and one drive bay
for a slim-type optical media drive.
Go to the HP website at www.hp.com and refer to the options list for this server model for the latest
information on supported hard drives and optical media drives.
System drive bays
Figure 3
Item Description
1 1-inch hard disk drive bays (two)
2 Optical media device bay
NOTE: The HDD bays support both non-hot-plug and
hot-plug SATA drives, as well as hot-plug SAS drives.
All manuals and user guides at all-guides.com
Contents 32