Directed Electronics 20.7 Owner's Manual page 27

Smart start
Command
: Press
Feedback
:
Notes
:
To activate the Smart Start Mode with a manual transmission:
1. Enter the MTS procedure.
2. Exit the vehicle and press the
shut down when locking).
3. Press the
4. The 2 way remote will beep once and "Smart Start On" is displayed in
the text area.
5. The parking lights on the vehicle will flash 5 times fast confirming entry into
smart start mode
6. The vehicle will now remote start when the cabin temperature reaches
the programmed thresholds or when the vehicle battery reaches the pro-
grammed voltage.
The Smart Start Mode can be exited by following the activation procedure with
the remote or can be deactivated manually by turning on the ignition or pressing
the brake pedal in the vehicle. The parking lights will flash 5 times slow confirm-
ing that Smart Start Mode is exited.
Details:
Smart start uses temperature and voltage settings to determine when the
vehicle should start and run. If any changes to temperature or voltage are made
using the Bitwriter programming tool Smart start activation is affected.
© 2008 Directed Electronics. All rights reserved.
AUX
three-times and then press
The parking lights flash 5 times fast and 'Smart Start On" dis-
plays in the text area.
Enables or disables the SmartStart feature. The smart start fea-
ture of this system will allow you to have the remote start ac-
tivate when the vehicle reaches a certain temperature (hot or
cold) or a certain voltage. The factory setting for temperature
high is 100 °F the setting for low is 0 °F. The voltage setting is
for 10.5V.
These settings can be adjusted or turned off by your installer
when using the Bitwriter.
AUX
button on the remote 3 times and then press the
button on the remote (the vehicle will
AUX
AUX
.
button.
AUX
27