MSI MS-6340M Manual page 52

Gate A20 Option
Normal
Fast
Typematic Rate Setting
Key strokes repeat at a rate determined by the keyboard controller. When
enabled, the typematic rate and typematic delay can be selected.
Settings: Enabled/Disabled.
Typematic Rate (Chars/Sec)
Sets the number of times a second to repeat a key stroke when you hold the
key down. Settings: 6, 8, 10, 12, 15, 20, 24, 30.
Typematic Delay (Msec)
Sets the delay time after the key is held down before it begins to repeat the
keystroke. Settings: 250, 500, 750, 1000.
Security Option
This category allows you to limit access to the system and Setup, or just to
Setup.
System
Setup
APIC Mode
This field is used to enable or disable the APIC (Advanced Programmable
Interrupt Controller). Due to compliance to PC2001 design guide, the system
is able to run in APIC mode. Enabling APIC mode will expand available IRQs
resources for the system. Settings: Enabled/Disabled.
The A20 signal is controlled by keyboard
controller or chipset hardware.
The A20 signal is controlled by port 92 or
chipset specific method.
The system will not boot and access to Setup
will be denied if the correct password is not
entered at the prompt.
The system will boot, but access to Setup will
be denied if the correct password is not entered
at the prompt.
3-9
AWARD BIOS Setup
®