Table of Contents
Advertisement
Installation Manual
•
Keep the unit upright during installation and level the unit in its final position. Once
in final position, leave unit for a minimum of 4 hours before activation.
•
Ensure that the airflow through the unit does not fall below 180 m3/h (50 l/s) during
operation.
•
Lifting point to be used for lifting the cooling module ONLY. It must not be used to
lift the Cooling Module plus MVHR.
•
Do not damage the pipes of the refrigerant circuit.
•
Do not use the unit if damaged, contact after sales.
•
In the event of gases escaping from damaged pipework, avoid contact with eyes.
1.1 Symbols
GENERAL WARNING
Signifies a general warning regarding hazard specified by supplementary information.
ELECTRIC SHOCK
This unit must be completely electrically isolated before any panels are removed. Check
mains supply and control connections.
COMPRESSED GAS
Liquefied Gas (R134a): H280: Contains gas under pressure; may explode if heated.
REFER TO INSTRUCTION MANUAL
Read and understand the installation and maintenance manual before installing,
operating or maintaining this product.
1.2 Important Information
This manual contains important information on the safe and
appropriate assembly, transport, commissioning, operation,
maintenance, disassembly and simple troubleshooting of the product.
While the product has been manufactured according to the accepted
rules of current technology, there is still a danger of personal injury or
damage to equipment if the following general safety instructions and
the warnings contained in these instructions are not complied with.
•Read these instructions completely and thoroughly before
working with the product.
•Keep these instructions in a location where they are accessible
to all users at all times.
•Always include the operating instructions when you pass the
product on to third parties.
Nuaire | Western Industrial Estate | Caerphilly | CF83 1NA | nuaire.co.uk
1.3 Personal Protective Equipment
The following minimum Personal Protective Equipment (PPE) is
recommended when interacting with Nuaire product:
•Protective Steel Toed Shoes - when handling heavy objects.
•Full Finger Gloves (Marigold PU800 or equivalent) - when
handling sheet metal components.
•Semi Fingerless Gloves (Marigold PU3000 3DO or equivalent)
- when conducting light work on the unit requiring tactile
dexterity.
•Safety Glasses - when conducting any cleaning/cutting operation
or exchanging filters.
•Reusable Half Mask Respirators - when replacing filters which
have been in contact with normal room or environmental air.
Nuaire would always recommend a site specific risk assessment by a
competent person to determine if any additional PPE is required.
10. 12. 21. Document Number 672010
MR-ECO-COOL-V
2
Advertisement
Table of Contents
