Delta UNISAW 36-L336 Instruction Manual page 12

BLADE GUARD ASSEMBLY
To attach blade guard assembly:
To reduce the risk of serious personal
injury, the blade guard assembly must be in place for all
possible cuts.
1. While holding the blade guard assembly (N) in a
vertical position, slide the locating pin (O) into the
riving knife slot (P) centering the riving knife within the
v-shaped notch in the top guard.
2. Rotate the blade guard assembly towards the front
of the saw while keeping the pin (O) at the top of the
riving knife slot. Rotate until the blade guard assembly
is parallel to the table. See Fig. 13.
3. While holding down on the front of the metal portion
of the guard (X), press the blade guard lock lever (Q)
Fig. 13 down until it snaps into the locked position,
as shown in Fig. 14. Check to make sure the guard is
locked onto the riving knife by pulling on the guard at
(R) Fig. 14. If the guard is not locked the blade guard
lock lever will flip up to the unlocked position, as
shown in Fig. 13.
To remove the blade guard assembly:
1. Lift the blade guard assembly lock lever (Q) Fig. 13 to
the unlocked position.
2. Rotate the guard back and slide pin from riving knife
slot.
MITER GAUGE ASSEMBLY
To assemble the miter gauge:
1. Place washer (S) Fig. 15 on threaded post at end of
miter gauge handle (T).
2. Tighten threaded post into hole (U) on miter gauge
body. Assembled miter gauge shown in Fig. 16.
3. Insert miter gauge bar end into either miter gauge slot
(V) on table (Fig. 17).
U
FIG. 15
S
T
X
R
FIG. 16
12
N
O
P
FIG. 12
Q
FIG. 13
FIG. 14
V
FIG. 17