Configuration Of The Wi-Fi Adapter Via The Provided Radio Network; Reset To Factory Settings; Updating The Firmware; 855_Icombipro-Icombiclassic-Scc_Wifi-Adapter_Im_Eu-West - Rational iCombi Pro Original Installation Manual

4 | Installation
4.2.5 Configuration of the Wi-Fi adapter
via the provided radio network
In Repeater mode, adjustments to the con-
figuration can be made wirelessly via the
provided radio network. To do this, log in
from a terminal that is connected to the
provided radio network (see
peater to expand existing WiFi
Make any adjustments.

4.3 Reset to factory settings

The WiFi adapter is reset to the factory
default with use of a magnet. To reset the
WiFi adapter, hold the magnet briefly in
the middle between the two antennas
above the LEDs until they flash at the same
time. Then wait a few seconds and then
start the configuration again.

4.4 Updating the firmware

a The WiFi adapter is connected to the
computer.
a There is a firmware file with the exten-
sion *.bin on the computer.
1. Get the latest firmware from the RA-
TIONAL customer service and the ser-
vice partner portal.
Logging in
1. Open a web browser and enter the ad-
dress https://192.168.11.1 or another
previously set IP address. Accept the
necessary certificates.
2. Enter the username and password. By
default the username is root and the
password is Rational [
>
Press the Login display text.
Update firmware
1. Select the System/Update Firmware
button.
80.51.855_iCombiPro-iCombiClassic-SCC_WiFi-Adapter_IM_EU-
west
2. Confirm the Update firmware display
3. Click the Browse display text. Select
4. Click the Upload display text.
} Use as a re-
5. Remove the check in the Maintain set-
coverage).
6. Confirm the update by clicking on the
7. Wait a few minutes for the green LED
>>
Photo 13].
text.
the firmware file saved on the com-
puter.
tings field.
>
The settings are reset.
Continue button.
>
Wait until the green LED goes out.
The blue LED lights up.
>
The unit must not be switched off.
to flash. The unit is accessible again.
Log in again.
The firmware has been successfully
updated.
en
17 / 108