Table of Contents
Advertisement
Installation
Caution!
1. The Installation must be carried out by an authorized dealer or trained professional.
2. Unit may cause severe injures, if you have doubts concerning the safety do not install.
3 Unit is to be 24 inches away from flammable materials.
4. Space between the base and surface should be properly sealed to avoid liquids entering the base unit.
When installing the fixture it is very important that you follow common safety procedured. Instillation requires extensive
experience including but not limited to calculating working loads and periodic safety ispections. If you lack these
qualifications, do not attempt the installation yourself, instead use a professional structural rigger.
The installation location of the fixture has got to be built in a way that it can hold 10 times the weight. Installation should
be checked at least one time every 2 years by a skilled technician.
Fig2
Fig1
Installation
Step 1: Remove the mounting brace (Fig1) by removing
the side screws (Fig3) on the fixture base.
Step 2: Secure the mounting brace to the electrical box
with screw. (Fig2)
Step 3: Make the necessary power connection using
the RJ45 in and out connections. Input and Output
can be connected to ether connection.
Step 4: Cover the last unused output connection with the
Fig3
RJ45 cover that is removed from the Deco Driver
output.
Step 5: Secure the fixture to the mounting brace using
fixture (Fig3 ) screws.
Step 6: To avoid water ingression into the fixture seal the
mounting to the surface using a silicone adhesive.
Step 7: Optional Accessory diffusion filter can be mounted by
unscrewing the front glass cover and snaping into the
metal glass holder from the inside. Keep in mind once
diffusion is mounted it is difficult to remove.
5
Advertisement
Table of Contents
