Main Power Connection; Dmx Driver - Deco PARLED Q10 User Manual

Main Power Connection

Caution!
1. Deco Lighting fixture are specifically designed to be used with Deco Drivers.
2. Maximum cable distance of 100ft before voltage drop. (Voltage drop will cause intensity drop)
3. Max Power 20W Deco Driver will power 2 per output.
4. Max Power 96W Deco Driver will power 9 per output.
5. All fixture connected together must be same type. ( Do not connect Variable White fixtures with RGBW
fixtures in the same output)
6. Must use Cat6A, 23AWG or thicker to connect the fixture to the driver and fixture to another fixture.
(Cable not included)
4 or 7 Channel Fixture
DMX-512 Control
When using the Deco Parled Q10 with Deco Drivers the fixture is intended to be used in Ch4 or Ch7 modes. The Deco
Driver will be required to be set in Ch4 or Ch7 dmx operating modes.
Deco Driver Info
Power Link 20W output Deco Drivers
96W output Deco Drivers
Ch Mode
Pin 1 Red-
2 Fixture Max per Output
Pin 2 24V+
Pin 3 Green -
Pin 4 24V+
Pin 5 Blue-
Pin 6 24V+
Pin 7 White-
9 Fixture Max per Output
Pin 8 24V+
(note all units connected
will perform the same function)
RJ45 Y jumper cable can be connected on ether side for input or output.
Ch4 Mode
Red
Green
Blue
Warm White
Can Connect 2 per output port
Can connect 9 per output port
Ch4 or Ch7 Use Ch4 or Ch7 mode to control the unit
Deco Driver with
20W output
Deco Driver with
96W output
Ch7 Mode
Dimmer
Red
Green
Blue
Warm White
Strobe
Macro
4