Fcc Warning; Supplier's Declaration Of Conformity; Mandatory Safety Instructions To Installers And Users - Kenwood NXR-1700 Instruction Manual

FCC WARNING

This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved by the party responsible/
JVCKENWOOD. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE
FCC
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can generate radio frequency
energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that the interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer for technical assistance.

SUPPLIER'S DECLARATION OF CONFORMITY

47 CFR § 2.1077 Compliance Information
Trade name: KENWOOD
Model(s): NXR-1700
Responsible party: JVCKENWOOD USA Corporation 1440 Corporate
Drive, Irving, TX 75038
Telephone number: 972-819-0700
MANDATORY SAFETY INSTRUCTIONS TO INSTALLERS AND
USERS
• Use only manufacturer or dealer supplied antenna.
• Antenna Minimum Safe Distance: Refer to the values in the table
below.
• Antenna Gain: 0 dBd referenced to a dipole.
The Federal Communications Commission has adopted a safety standard
for human exposure to RF (Radio Frequency) energy which is below the
OSHA (Occupational Safety and Health Act) limits.
• Antenna Mounting: The antenna supplied by the manufacturer or
radio dealer must not be mounted at a location such that during
radio transmission, any person or persons can come closer than the
minimum safe distance indicated in the table below.
• To comply with current FCC/ ISED RF Exposure limits, the antenna
must be installed at or exceeding the minimum safe distance shown
above, and in accordance with the requirements of the antenna
manufacturer or supplier.
• Vehicle installation: The antenna can be mounted at the center of a
vehicle metal roof or trunk lid, if the minimum safe distance is observed.
• Base Station Installation: The antenna should be fixed-mounted on
an outdoor permanent structure. RF Exposure compliance must be
addressed at the time of installation.
Antenna substitution: Do not substitute any antenna for the one supplied or
recommended by the manufacturer or radio dealer.
You may be exposing person or persons to excess radio frequency
radiation. You may contact your radio dealer or the manufacturer for further
instructions.
WARNING
Maintain a separation distance from the antenna to person(s) of at least
the distance indicated in the table below.
You, as the qualified end-user of this radio device must control the exposure
conditions of bystanders to ensure the minimum separation distance (table
below) is maintained between the antenna and nearby persons for satisfying
RF Exposure compliance. The operation of this transmitter must satisfy the
requirements of Occupational/Controlled Exposure Environment, for work-
related use, transmit only when person(s) are at least the minimum distance
from the properly installed, externally mounted antenna. Transmit only when
people outside the vehicle are at least the recommended minimum lateral
distance away from the antenna/vehicle.
Antenna Minimum Safe Distance
NXR-1700-E 160 cm (5.3 feet)