Removing Excess Humidity - Danby DAC12344DE Owner's Instructions Manual

Removing Excess Humidity

Remote Control Control Panel
10
E-
If the atmosphere in your room is very humid or damp, you can remove
excess humidity without lowering the room temperature too much.
1 If necessary, press the
Result: The air conditioner starts up in the Cool mode.
The unit beeps.
The air conditioner is fitted with a protection mechanism to pre-
vent the unit from being damaged when it is started immediately
after being:
Plugged in
Stopped
It will start up normally after three minutes.
2 If the temperature is not displayed at the top of the control panel, press
the button on the control panel one or more times until it
Mode
Cool/Dry/Fan
appears.
Result: The unit beeps each time you press the
The air conditioner runs in Dry mode.
You can change modes at any time.
3 To adjust the temperature, press the
more times until the required temperature is displayed.
Possible temperatures are between 18 C and 30 C inclusive.
Result: Each time you press the
- The temperature is adjusted by 1 C
- The unit beeps
The air conditioner starts removing the excess humidity;
the quantity of air is adjusted automatically.
4
To control the direction of the air flow, refer to page 11.
(On/Off) button.
Mode
Cool/Dry/Fan
or buttons one or
or buttons:
button.