PIVOT products maximize protection and minimize the need to remove the device from your PIVOT case. If you need to remove your device, please refer to this document or visit PIVOT online for instructions to avoid unnecessary damage to your device and PIVOT case.
Page 3
Installing PA-CB-1 Camera Blockers 1)Clean camera surface and surrounding using manufacturer’s recommended methods. 2)Check for fit/compatibility with device and PIVOT case before final application. 3)Remove PA-CB-1 adhesive backing, align the hole on the sliding camera blocker with device camera and lightly place blocker into position.
Page 4
Installing PA-CB-2 Camera Blockers 1)Clean camera surface and surrounding using manufacturer’s recommended methods. 2)Check for fit/compatibility with device and PIVOT case before final application. 3)Remove PA-CB-2 adhesive backing, align the hole on the sliding camera blocker with device camera and lightly place blocker into position.
Page 5
Microphone Blocker: Installing PA-MB-1 Microphone Blocker 3.5mm 1)The PA-MB-1 fits only standard 3.5mm headphone jacks. 2) Remove the audio block from the case. 3) Insert the PA-MA-1 into the audio jack of the device. 4)Remove the PA-MB-1 to restore microphone function.
Put the stickers to cover the rear and front camera. Installing Device Align device camera and buttons with the corresponding access points in the case body. Ensure that nothing is misaligned or otherwise obstructing the installation of the device into the case body.
Page 7
Place the device into the back of the case body. Ensure the device is properly aligned inside of the case back. If misaligned, remove and try again. Press the front frame of the case body over the front face of the device.
Thank you. Additional Information To learn more about your PIVOT case, please visit pivotcase.com for instructional videos, product support and additional information about PIVOT products. You’ll find valuable online resources provided to enhance your user experience and see the complete line of PIVOT products.