Table of Contents
Advertisement
CAUTION Most specialty or modified vehicles
cannot be raised on a frame engaging or pad
lift. Contact vehicle manufacturer for raising
or jacking details.
3.
Before lifting the vehicle be sure that:
A. Individual axle weight of vehicle does not
exceed one-half lift capacity. See safety
instructions (capacity).
B. Vehicle is stable on lift and neither front
nor rear heavy.
CAUTION With some vehicles, the removal
(or installation) of heavy components may
cause a critical shift in balance and result in
vehicle instability. Refer to the vehicle
manufacturer's
recommended procedures when performing
these services.
File: MR6-IOM-Q.doc
Model QMR6
Installation, Operation, and Maintenance
service
manual
for
Raising Vehicle
4. To raise lift:
A.
Actuate RAISE switch on electric power unit.
B.
Raise vehicle until tires clear floor.
C. Check to make sure all four contact pads
are secure on the vehicle.
D. Continue to raise to desired height ONLY if
vehicle is secure on lift.
E.
Once you have reached the required height
set into lock by depressing the lowering
handle.
Lowering Vehicle
5. To lower lift:
Stand clear of lift and vehicle when
Observe pinch point warning decals.
A.
Remove all tools or other objects from lift area.
B.
Raise
vehicle
disengage lock.
C.
Push LOWERING valve handle to lower lift.
CAUTION Lowering handle must be held
down to continue to lower lift. DO NOT
override self-closing lift controls.
6. Before moving vehicle, be sure lift is at the fully
lowered position and is clear of any tools or
objects.
NOTE:
The lock bar will reset automatically when the lift is
fully lowered or raised a minimum of 1". If during
the lowering process the lift is stopped before it
gets to the fully lowered position. Reset by
repeating steps 5 or 6 from above.
8
lowering.
approximately
1"
to
Rev: 3/26/09
Advertisement
Table of Contents
