Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DAN DRYER 372-373
Summary of Contents for DAN DRYER 372-373
- Page 1 USER MANUAL AIRTAP BUILD-IN HAND DRYER Model: 372-373...
-
Page 2: Table Of Contents
DIMENSIONS AND TECHNICAL SPECIFICATIONS TABLE OF CONTENTS Dimensions and technical specifications Dimensions Unit of measurement: mm General safety information Circuit diagram Ø38 34,5 Installation Installation height User guide Cleaning and maintenance Adjustment of warm air speed output Heating element switch 148,5 Adjustment of sensor range Troubleshooting and corrective actions... -
Page 3: General Safety Information
• The product should be checked on a regular basis. Never use a defective or malfunctioning unit. • Never make alterations to the product affecting its performance. DAN DRYER’s product warranty does not cover product problems that result from misuse or alteration. -
Page 4: Installation
INSTALLATION INSTALLATION Make sure the main breaker is turned off. Installation must be carried out by a qualified person in accordance with applicable standards in the country concerned. 6. Mount unit cabinet to the wall. Insert power cord 1. Check the required distance from 2. - Page 5 • Ensure unit is installed on solid and stable background. • If in doubt, contact DAN DRYER IMPORTANT! Make sure to position the Secure blind plug in the cap to provide an airtight seal. plugs correctly. 11. Connect earthing.
-
Page 6: Installation Height
INSTALLATION HEIGHT CLEANING AND MAINTENANCE OF CABINET/MOTOR • Cut the power • Unscrew (2) bottom security screws • Remove cabinet front • Clean the cabinet inside and remove dust/dirt. Compressed air can be used RECOMMENDATION: • Do not rinse with running water Tolerance for position of flexi hose from •... -
Page 7: Heating Element Switch
TIMER SETTINGS TROUBLESHOOTING AND CORRECTIVE ACTIONS SYMPTOM CORRECTIVE ACTION: NEW HAND DRYER AIR SPEED ADJUSTMENT Hand dryer does not start • Check power supply to the product and ensure the connections at the terminal block are made properly. • Switch off power and remove front cover Hand dryer cycles by itself and •... -
Page 8: Parts List
PARTS LIST Tap inner parts Description Description Sensor housing (upper part) Blower housing (upper part) 3 + 4 Sensor + outlet branch Motor rubber (upper part) Silicone lining Motor Holder for LED circuit board Heating element LED circuit board Motor rubber (lower part) End piece Blower housing (lower part) Cabinet (front part) - Page 9 DAN DRYER A/S Alsikevej 8 DK - 8920 Randers NV Tel: +45 8641 5711 Email: info@dandryer.com dandryer.com...
Need help?
Do you have a question about the 372-373 and is the answer not in the manual?
Questions and answers