Connecting The Switch; Switch To End Node - D-Link DGS-1008D User Manual

Connecting The Switch

Switch To End Node

Switch To Hub or Switch
Connecting To a Server
NOTE: All 8 high-performance NWay Ethernet ports can support both MDI-II
and MDI-X connections.
Switch To End Node
End nodes include PCs outfitted with a 10, 100 or 1000 Mbps RJ-45 Ethernet/Fast Ethernet Network Interface
Card (NIC) and most routers.
An end node can be connected to the Switch via a twisted-pair Category 3, 4, or 5 UTP/STP cable. The end node
can be connected to any of the ports of the Switch.
The Link/Act LEDs for each UTP port light green when the link is valid. The LED over the port label indicates
a port speed of either 10/100 Mbps or 1000Mbps. A blinking LED on the bottom indicates packet activity on that
port.
D-Link DGS-1008D Unmanaged Gigabit Ethernet Switch
Figure 3-1. Switch connected to an end node
9
Section 3