Removing An Ssd Module - Cisco Catalyst 9500 Series Hardware Installation Manual

Installing Field Replaceable Units

Removing an SSD Module

Procedure
Step 1 Depending on your switch model, do one of the following:
• On Cisco Catalyst 9500 Series High Performance switches, press and hold the hot-swap button on the
• On Cisco Catalyst 9500X Series switches, loosen the two screws on the SSD module.
Step 2
Remove the SSD module from the module slot and insert the blank slot cover.
If you are replacing the SSD module, insert the new module into the slot. For more information, see
an SSD Module, on page
SSD module for atleast four seconds.
The system powers down the SSD module and the port and the LED turns off indicating that the module
is ready for removal.
Also, the switch console displays the following messages indicating safe removal.
*Mar 12 11:22:22.285: %IOSXE-3-PLATFORM: R0/0: kernel: ata1: irq_stat
0x00400040, connection status changed
*Mar 12 11:22:28.310: %IOSXE-4-PLATFORM: R0/0: kernel: ata1: limiting
SATA link speed to 1.5 Gbps
*Mar 12 11:22:33.613: %IOSXE-4-PLATFORM: R0/0: kernel: ata1.00: disabled
77.
Cisco Catalyst 9500 Series Switches Hardware Installation Guide
Removing an SSD Module
Installing
79