Cisco Catalyst 9500 Series Hardware Installation Manual page 44

Rack-Mounting
• Installation in racks other than 19-inch racks requires a bracket kit not included with the switch.
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special precautions to
ensure that the system remains stable. The following guidelines are provided to ensure your safety:
• This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
• When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the
heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the
unit in the rack.
Statement 1006
Figure 24: Four Post Rack Mount Kit for Cisco Catalyst 9500 Series Switches
This figure shows the four post rack mount kit for Cisco Catalyst 9500 Series Switches. You can order the
optional brackets from your Cisco sales representative.
1
2
3
Cisco Catalyst 9500 Series Switches Hardware Installation Guide
36
Two 19-inch brackets
Extension rails and brackets for four-point
mounting
Eight number-12 Phillips pan-head 0.50"
long screws
4 Eight number-10 Phillips pan-head 0.625"
long screws
5 16 number-8 Phillips flat-head 0.312" long
screws
- -
Installing a Switch