Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched. Remove all wrapping material, including staples & packing straps before you start to assemble. DO NOT tighten all screws and bolts until completely assembled. Keep all hardware parts out of reach of children.
HARDWARE LIST When unpacking, please be careful not to discard any parts with the packaging. Before continuing, please make sure you have all of the following hardware: Description Sketch Description Sketch Bolt Lock washer 4PCs 4 PCs (M8x40) ( F8.5xF13mm) Flat Washer Allen key ( F8.5xF19mm)
Page 4
STEP 2 Attach Revolving fitting (8) to the leg by using bolts (5) and washers (6) and (7). Tighten with Allen Key (4) as shown on the picture below: STEP 3 Attach Revolving fitting (8) to the Seat Frame by using bolts (5) and washers (6) and (7). Tighten with Allen Key (4) as shown on picture below: STEP 4 Put the chair on a flat level surface to make sure the chair is level and then tighten the all bolts.