Table of Contents
Advertisement
IM-HC 599871 0321 RABS
Proceed as follows to add new control units:
Figure 36: Add a control unit
X
Click on "Add" new device in the top menu bar.
To establish the connection, you will need the serial number and the
password of the WLAN module. This data is to be found on a label on
your WLAN module.
X
Enter the serial number and password of the WLAN module.
X
Use the Object selection menu to select an existing object or
generate a new object.
X
Press "Add" to confirm your entry.
Z The control unit establishes a connection with the object. You
return to the device overview.
If you wish to add further control units, repeat the instructions in this
section.
Proceed as follows to manage the objects and control units in the
device overview:
Figure 37: Device overview with a list of the connected control units
Software Set-Up Procedures
67
Advertisement
Table of Contents
