Advertisement
Step 2
å
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as
shown in the upper diagram below. Be prepared, the parts are greasy.
å
Fasten one EXTENSION RAIL (35MA) to the RIGHT END (A). Use two SILVER 1/2" FLAT
HEAD SCREWS (128S) through holes #1 and #3.
å
NOTE: For the EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other hole
that lines up with the hole in the END. Turn a SCREW into this hole.
å
NOTE: The EXTENSION SLIDES (35MC) will be used later for the DRAWER.
Push the black lever in and pull the SLIDE from the RAIL.
Edge with
TWIST-LOCK®
FASTENERS
Page 6
35MC
A
35MA
SILVER 1/2" FLAT HEAD SCREW
(2 used for the RAIL)
1
2
3
128S
Open end
Advertisement
