Teknik 5426509 Manual page 24

Step 20
1
D14
N
Groove
å
Insert the DRAWER SIDES (D14 and D15) at an angle
into the slot at each end of the DRAWER FRONT (N).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
å
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D14 and D15).
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the groove of
the DRAWER BACK (D78).
Page 24
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D78
D14
D716
2
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
å
Slide the DRAWER BOTTOM (D716) into the grooves in the
DRAWER SIDES (D14 and D15) and DRAWER FRONT (N).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
With the palm of
your hand, tap
the DRAWER
BOTTOM down
U n fi
into the groove.
n i s h
s u r
e d
f a c
e
D716
D15
N
30S
(4 used in this step)