Leak Testing; How To Check For Leaks - Coleman 9995- Series Instructions For Use Manual

To Set Up
continued
Step 6
LEFT LID (SHELF)
CENTER LID
Unlock Right Side Lid.
NOTE: Undo latches on
front and back of lid.
Release flaps to form
Right Side Shelf.
IMPORTANT: Always remove Lids in this order:
•
Right Lid first.
•
Left Lid second.
•
Center Lid last.
Carefully insert Shelf Lip
on Right Side Shelf into Top
Channel, while at the same time
making sure the Notches on the
side Flaps fit into the Flanges
on the grill body.
DETAIL "A"
SHELF LIP
TOP CHANNEL
DETAIL "B"
NOTCH
FLANGE
Repeat the same order for attaching the Left Side Shelf as you did
on the Right Side Shelf.
Remove Center Lid and set aside until ready for storage of the grill.
8
RIGHT LID (SHELF)
LID FLAPS
SHELF LIP
TOP CHANNEL
NOTCH
FLANGE
To Set Up
continued
Step7
Install two Grease
Pans from front as
shown.
Step 7
Install 9-Volt Battery
with positive (+) terminal
as shown on Igniter
Module.

Leak Testing

DANGER
T P F E
O REVENT IRE OR XPLOSION
• NO SMOKING. DO NOT use or permit sources of ignition
in the area while doing a leak test.
• Perform leak tests outdoors only.
• NEVER perform a leak test with fire or flame.

How to Check for Leaks

1. Make a soapy solution of equal parts mild liquid dishwashing
detergent and water.
2. Turn off all burner control knobs.
3. Turn on fuel supply. Turn cylinder valve knob counterclock-
wise (right to left) one rotation.
4. Apply soap solution to connections indicated with arrows in
Fig. 15. If bubbles appear at these areas, a leak is indicated.
15
Igniter Module
H :
AZARD