Change Administrator Password - Elen NDA 100/3-2 TH RG L20 230AC LAN User Manual

MODBUS Settings for Sensor No.2
Sensor No. 1 Function
Sensor No. 2 Register address for temperature
Sensor No. 2 Register address for humidity
Note: Do not forget to press the Set button after making each change.
Otherwise the change will be discarded. When finished with settings, click the Refresh button.
Stop bits are set automatically according to parity settings as per MODBUS protocol specifications.
(Valid for all communication interfaces of display.)
It is possible to reset the IP address back to factory default value by pressing and holding the RESET button
5 seconds. The RESET button is located near the external sensor connector P1 on the back panel.
for

Change administrator password

Enter new password if you want to change it.
Default password is "admin".
Click on the "save new password" button when finished.
Current password
New password
Confirm new password
User Manual / NDA 100/3 TH(S) RG L20 230AC(PoE) LAN
3, 4
Function number, which is used for reading temperature and humidity values.
Default: 4. (Default for ELEN sensors.)
0 to 65535
Address of register, which contains temperature value.
The temperature value must be signed int and in tenths of °C.
Default: 0. (Default for ELEN sensors.)
0 to 65535
Address of register, which contains humidity value.
The humidity value must be signed int and in tenths of %RH.
Default: 10. (Default for ELEN sensors.)
Enter current password.
Enter new password, max. 10 characters.
Re-enter new password.
17