Table of Contents
Advertisement
Display settings
Display mode
Sensor No. 1
Display will show measured value from sensor No. 1 as configured above.
Sensor No. 2
Display will show measured value from sensor No. 2 as configured above.
Average from 2 sensors
Display will show average value from 2 sensors, if two sensors are connected.
Brightness mode
Automatic Automatic control of brightness according to ambient light conditions,
Direct
Brightness level (1 – 100)
If Direct mode is selected above, this value sets fixed LED brightness level from 1 to 100.
Curve slope (1 – 100)
If Automatic mode is selected above, this value sets the slope of brightness regulation curve.
Display ID
USB virtual serial COM port settings
Baud Rate
Parity
MODBUS RS-485 Serial Settings
Baud Rate
Parity
MODBUS TCP/IP Settings
MAC
IP address
14
Sensor No. 1 / Sensor No. 2 / Average from 2 sensors
Automatic / Direct
via built-in light sensor.
Direct control of brightness via fixed brightness level entered by user.
Default factory setup is automatic.
1 – 247
Designates internal RS485 address ID number of display.
(MODBUS slave address.)
1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200.
Baud rate for USB communication interface (default: 19200 Bd)
None, Even, Odd
Parity type settings for USB interface (default: EVEN)
1200, 2400, 4800, 9600, 14400, 19200, 38400, 57600, 115200.
Baud rate for RS485 communication interface (default: 19200 Bd)
None, Even, Odd
Parity type settings for RS485 interface (default: EVEN)
Shows MAC address of connected display.
User cannot change this field.
Shows IP address of display (same IP address as in the URL field of the browser).
Factory default IP address is on the label located on the back panel of display.
Enter new IP address according to your LAN setting.
User Manual / NDA 100/3 TH(S) RG L20 230AC(PoE) LAN
Advertisement
Table of Contents
