Advertisement
Quick Links
ACC514, ACC516 - Quick Start Guide
·
Handle the equipment carefully, holding force can be reduced by damaging the bolt body or detector plate.
·
The electric bolt lock should be fixed tightly on the door frame and the detector plate on the door leaf.
·
Shut off all power to the access control system before wiring this device.
·
Maintain a clean and safe environment at all times.
Definition
NO (Normally Open) - This is a contact which remains open (as default) until activated, during the "active" state
the contact provides a closed circuit and starts conducting.
NC (Normally Closed) - Is the opposite of a NO contact. The contact will remain closed (as default) until
activated, during the "active" state the circuit breaks and stops current flow.
Connections
ACC514
Red
= +12V DC
Yellow
Black = GND
White
Purple
Setup Example
Electric bolts are an efficient method of adding secure access control to a
door.
An electric bolt will protrude out as long as there is power being supplied
and then detector plate is present.
For a "Fail Safe" setup, when the button is activated, power supply
then releases power from the lock, and if power is lost then the lock
also releases.
You would connect the control device and power to the bolt via an access
control panel, relay or exit button so that the power can be cut when
triggered. When powered up again the bolt protrude again locking the
door in place.
Quick Start Guide - qACC514, qACC516
1
Electric Bolts
The ACC514 has an adjustable delay and status relay output which
can be connected to a buzzer or light to produce a visible or audible
alert when the door is opened.
The ACC516 has an adjustable delay of up to 6 seconds, a relay
output to alert when the door is opened and LED indicator to show
the bolt status.
User Information
·
There are no user serviceable parts, opening or attempting to
repair the product will void the warranty.
·
Do not install or use the device if the wires connected are
damaged or have been subjected to water ingress
= NO
= COM
= NC
Zap is a registered trademark of System Q Ltd
ACC516
Red
= +12V DC
Black = GND
Electric Bolts
Yellow
= NC
White
= COM
Copyright 2022 System Q Ltd
Advertisement
Related Manuals for Zap ACC514
Summary of Contents for Zap ACC514
- Page 1 Zap is a registered trademark of System Q Ltd ACC514, ACC516 - Quick Start Guide Electric Bolts The ACC514 has an adjustable delay and status relay output which can be connected to a buzzer or light to produce a visible or audible alert when the door is opened.
- Page 2 Electric Bolts Zap is a registered trademark of System Q Ltd Mounting ACC514 1. Cut a rebate in the door for the detector plate, and cut the hole for the electric bolt using the template provided. 2. Ensure a channel or hole is made for the cables and ensure they are protected by using a protection guard or conduit if exposed.